336 Part III . Choosing and Installing a (Web servers)
336 Part III . Choosing and Installing a Linux Distribution You can install all packages that are selected by default in the OpenSUSE install process from the OpenSUSE 10.0 disk #1 image that comes with this book. If you want to install additional packages, you need to either get CDs 2 5 yourself or install the packages over the network after the initial install is complete. Choose each group selection to see the specific packages in each group. Check boxes indicate which packages you want to install. It s a good idea to look through this list to see what you are getting. If you change any of the selections, click the Check Dependencies box to make sure that all packages that other packages depend on are being installed. Figure 10-3 shows the YaST module for adding, removing, and finding out about software packages. Figure 10-3: Install and remove software using the YaST software module. The YaST software packages module used during installation is the same one used on a running SUSE system (in Figure 10-3, it s shown on a running SUSE system). In either case, you can find out a lot of information about packages that interest you. With a package selected, click tabs in the box at the bottomright corner of the screen to see its description, technical data (its size, packager, and so on), dependencies, and version numbers. 12. Booting. Select Booting to see the information that is added to your boot loader (GRUB, by default, but you can use the LILO boot loader as well). The boot loader includes the information needed to boot Linux: the location of the boot loader, default operating system to boot, and other information. Note
If you are looking for cheap and quality webhost to host and run your website check Jboss Web Hosting services.